Live Repeater - SanJose & Cupertino streaming

Question

Question by Karl Hindson · May 30, 2012 at 12:09 PM · live streaming and encoders

Live Repeater - SanJose & Cupertino streaming

Hi,

I have setup a origin server and a separate edge server. I have tested the rtmp streams successfully and can view using the simple published stream name.

I have followed the required steps to allow iOS & Flash HTTP streaming, but cannot get these to work. I just see:

FLASH:

HTTPStreamerAdapterSanJoseStreamer.service: Request timeout: 8000

iOS:

HTTPStreamerAdapterCupertinoStreamer.service: Request timeout: 8000

The forum posts I have found indicate it could be possible network issues, however I can successfully watch the rtmp streams without any issues.

Appreciate any help.

Thanks

0

10 |600 characters needed characters left characters exceeded

Attachments: Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Answer 1 · 2012-05-30T21:11:49Z

Answer by Richard Lanham · May 30, 2012 at 09:11 PM

Great! Glad it's working. Thanks for the update

Richard

0 · Share

10 |600 characters needed characters left characters exceeded

Attachments: Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Answer 2 · 2012-05-30T20:16:41Z

Answer by Richard Lanham · May 30, 2012 at 08:16 PM

It does appear to be a connectivity issue between the edge and the origin. I assume you see those log messages on the edge logs. If you can run a browser on the edge, check:

http://[wowza-origin-address]:1935

Richard

0 Show 2 · Share

10 |600 characters needed characters left characters exceeded

Attachments: Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Karl Hindson · May 30, 2012 at 08:38 PM 0

Share

That works giving the following: Wowza Media Server 3 Monthly Edition 3.1.1 build1479

I also tried that on the edge & I get the same.

I can pull direct off the origin with the following server address: rtmp://origin.ourdomain.net:1935/liveorigin

This matches our edge config: <OriginURL> rtmp://origin.ourdomain.net:1935/liveorigin</OriginURL>

I can pull direct off the edge: rtmp://edge.ourdomain.net:1935/liveedge/

And yes, I see those errors on the edge. The origin gets the request and I see:

MediaStreamHTTPStreamerRepeaterOriginPlay.initLiveStreamRepeating: playerClass: com.wowza.wms.httpstreamer.cupertinostreaming.liverepeater.CupertinoStreamerLiveRepeaterPlayer

Karl Hindson Karl Hindson · May 30, 2012 at 08:54 PM 0

Share

Ok... Strangest thing. I just restarted the origin and it's started working!!

Was starting to frustrate me as it all looked like it should work. I need to do some more tests, but so far, so good!

Thanks

Answer 3 · 2012-05-30T13:14:41Z

Answer by Richard Lanham · May 30, 2012 at 01:14 PM

Have you set up the correct LiveStreamPacketizers on the origin and the edge. They are different. Take a look at this guide:

http://www.wowza.com/forums/content.php?227-Liverepeater-Quick-Start

If you are doing multi-bitrate streaming, and there are other good reasons to use this alternative configuration in which packetizing occurs on the edge.

http://www.wowza.com/forums/content.php?401-How-to-lock-multi-bitrate-stream-on-Liverepeater-edge

Richard

0 Show 2 · Share

10 |600 characters needed characters left characters exceeded

Attachments: Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Karl Hindson · May 30, 2012 at 02:19 PM 0

Share

Hi,

I have the following, which look to be correct:

Edge:

<LiveStreamPacketizers>sanjosestreamingrepeater, cupertinostreamingrepeater, smoothstreamingrepeater</LiveStreamPacketizers>

Origin:

<LiveStreamPacketizers>cupertinostreamingpacketizer, smoothstreamingpacketizer, sanjosestreamingpacketizer</LiveStreamPacketizers>

We're not currently doing multi-bitrate streaming, though I will look at this alternative config for future reference.

Karl Hindson Karl Hindson · May 30, 2012 at 05:14 PM 0

Share

The origin is actually:

<LiveStreamPacketizers>cupertinostreamingpacketizer, smoothstreamingpacketizer, sanjosestreamingpacketizer</LiveStreamPacketizers>

The space above was a typo.

I still get the timeout, any ideas?

Thanks

Live Repeater - SanJose & Cupertino streaming

3 Replies

Your answer

Follow this Question

Related Questions

Hot Topics

Product Sign-in

Under the Hood

Partners

Company

Stay Connected

Sign Up for Our Blog

Select a Language