Decoding RTSP/RTP Stream Using Teradek Cube

[M_P1]

I need to decode a feed from Wowza steaming engine, according to Teradek it’s doable, just like pulling any other RTSP/RTP stream. Where can I find the following info from the Wowza streaming engine webUI?

PROTOCOL=

HOST=

PORT=

NAME=

USERNAME=

PASSWORD=

Thanks

[sal_jefferson]

Hello there and welcome to the Wowza support forum. Please have a look at this guide:

How to connect the Teradek Cube to Wowza Streaming Engine

Regards,

Salvadore

[Andy_Engberson]

Hi

It is possible to have an rtsp stream without a password. By default password authentication is turned on but you can change the settings. We have an article here on how to enable-username-password-authentication-for-RTMP-and-RTSP-publishing.

Andy_E

[M_P1]

Hi. Thanks for the reply. I need to decode the feed those instructions are to encode with a Cube encoder which was pretty easy to set. I guess if there’s no password it’s straight forward all RTSP addresses are the same?

Server URL: rtsp://[wowza-ip-address]:1935/live

Stream Name: myStream

User: publisherName

password: [password]

Example; rtsp://123.123.123:1935/live

Is it possible to have no password on a stream?

Thanks

Hello there and welcome to the Wowza support forum. Please have a look at this guide:

How to connect the Teradek Cube to Wowza Streaming Engine

Regards,

Salvadore