Results 1 to 2 of 2

Thread: How to know if it is multicast or unicast

  1. #1

    Default How to know if it is multicast or unicast

    I use the module Multicast Publish as instructed. In the conf/multicastmap.txt I just left it empty. I teseted with VLC the following rtsp link

    rtsp://[wowza-ip-address]:1935/edge/xxjjkshjou?multicastplay

    VLC can stream it with no problem. My question is how do I know if this is multicast or unicast? Again I note that there is nothing in the file multicastmap.txt

    Thanks

  2. #2

    Default

    By the address being used to stream the content. This article covers the ranges:

    http://en.wikipedia.org/wiki/Multicast_address

    You can see the addresses being used for delivery in the Wowza Server logs when playback starts.

    Charlie

Similar Threads

  1. is this multicast or unicast?
    By telcotrader in forum General Forum
    Replies: 2
    Last Post: 11-26-2013, 07:23 AM
  2. Replies: 6
    Last Post: 12-10-2012, 11:57 AM
  3. restream from multicast to udp unicast
    By ghost_rider in forum Live Streaming and Encoder Discussion
    Replies: 2
    Last Post: 11-23-2012, 04:06 AM
  4. How i can PUSH udp multicast in to rtsp unicast over TCP
    By spacedvb in forum Live Streaming and Encoder Discussion
    Replies: 0
    Last Post: 01-06-2012, 10:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •