Results 1 to 2 of 2

Thread: Performance question from tutorial

  1. #1

    Default Performance question from tutorial

    In the tutorial it says to change in the file WowzaMediaServer-Service.conf. But when I go to that file I see the following entry:

    "#[do not use - see property]"

    should I edit this with the information from the tutorial discussion:

    If so do I add this to the end of the file?


  2. #2
    Join Date
    Sep 2011


    You can edit :
    to :

    The lines
    "#[do not use - see property]"

    Are telling you that you set the memory in "" not "".
    admittedly its not crystal clear but if you set as shown above it will be correct.


Similar Threads

  1. Performance/Hardware question
    By onyx808 in forum Performance Tuning Discussion
    Replies: 2
    Last Post: 10-08-2013, 08:26 PM
  2. Question about performance of transcoder
    By aclimaco in forum AddOn: Transcoder
    Replies: 1
    Last Post: 05-23-2012, 10:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts