Results 1 to 2 of 2

Thread: connect to RSTP incoming stream programmatically

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Oct 2014

    Default connect to RSTP incoming stream programmatically

    I am new to Wowza, testing the capabilities.
    I followed the instructions of the post "How to re-stream video from an IP camera (RTSP/RTP re-streaming)"
    and I will use the Microsoft Smooth Streaming or/and the ADOBE HDS.
    My question has to do with the behavior of the incoming RSTP streams.
    Can we control the already defined stream in server (or even to create it on-fly ), programmatically ?
    to start the streaming when we want and to disconnect when we don't need it any more ?
    In our system, we have few seconds(2-3) before the user actually starts the player. We need low latency <= 1 sec, during the streaming.
    We have locations with a number of cameras and we should connect them , based on the incident or by the frequency of recent history.
    So, using a web service to control the streams/channels in the server , is the best solution in terms of resources optimization.

    Last edited by stefan_ts; 10-12-2014 at 09:47 PM.

Similar Threads

  1. advice on how to create a stream programmatically
    By tartartartartar in forum Server-side Modules and Code Samples Discussion
    Replies: 1
    Last Post: 01-02-2014, 05:19 PM
  2. How to check source stream status - MediaCasterConnection.connect: Failed to connect
    By herkules in forum Live Streaming and Encoder Discussion
    Replies: 1
    Last Post: 11-20-2013, 07:11 PM
  3. Replies: 7
    Last Post: 04-02-2013, 08:31 AM
  4. control receive stream(stream manager) programmatically?
    By sktniran in forum Live Streaming and Encoder Discussion
    Replies: 2
    Last Post: 11-22-2011, 12:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts