Results 1 to 2 of 2

Thread: SBR and ABR RTMP Push Live with Edgecast - Proper PushPublishMap Syntax

  1. #1

    Default SBR and ABR RTMP Push Live with Edgecast - Proper PushPublishMap Syntax

    I have found one document suggesting proper mappings to push RTMP to Edgecast.
    To push to EdgeCast, use the rtmp profile. The rtmp profile is pre-configured to push to an RTMP CDN. When pushing to EdgeCast, the following account information is required:
    Live Authentication Key

    Following is an example entry to push the stream myStream to EdgeCast, assuming these credentials:
    ApplicationID: 200001
    StreamName: myStream
    Live Authentication Key: 0123456

    My question is: What determines the ApplicationID, above listed as 200001?

    Example map entry:
    myStream={profile:"rtmp", host:"", application:200001, streamName:"myStream?0123456", originalTimecodeThreshold:0x100000}

    Here is my mapping for Single Bit Rate. Can someone help me determine what I need to change?

    livestream.stream_360p={profile:"rtmp", host:"", application:"default" streamName:"XXXXX-stream4?XKeyX&adbe-live-event=XXXXX", originalTimecodeThreshold:0x100000}

    Also, if I were to send three bitrates, 480p and 720p, what would be changed in the above??



  2. #2
    Join Date
    Jan 2015


    Hi Clayton,

    The applicationID should be information that you get from Edgecast. Also, multi-bitrate push publishing to edgecast was covered in a tutorial thread by one of our users. There should be no changes in the map settings except for the streamnames.


Similar Threads

  1. Replies: 3
    Last Post: 10-07-2015, 07:55 AM
  2. Wowza to push SmoothStreaming Content to Edgecast
    By Terrycheung in forum Live Streaming and Encoders
    Replies: 2
    Last Post: 09-24-2014, 11:50 PM
  3. HLS push/pull to Edgecast
    By BargainsBeyond in forum Live Streaming and Encoders
    Replies: 6
    Last Post: 08-28-2014, 09:17 AM
  4. Push Publish add on edgecast
    By el3anchoke in forum AddOn: Other AddOns
    Replies: 4
    Last Post: 08-21-2013, 11:52 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts