I have ABR streams setup successfully for one application but struggling on another.
The one that works is a live streaming from FMLE and all runs as expected.
http://media.ppcnseo.com:1935/live/ppmg/playlist.m3u8 full stream
http://media.ppcnseo.com:1935/live/mp4:ppmg_360p/playlist.m3u8 transcoded stream
On the incoming streams page on streaming manager it shows the transcoder streams as separate lines.
The application with issues is a different setup, re-streaming RTSP streams coming from a collection of IP cameras.
http://s1.thailandstreaming.net:1935/lkmetro/backpacker1.stream/playlist.m3u8
With the source stream address located inside backpacker1.stream file.
First question, what would the correct URL be once things are working ok.
http://s1.thailandstreaming.net:1935/lkmetro/backpacker1_360p.stream/playlist.m3u8
http://s1.thailandstreaming.net:1935/lkmetro/backpacker1.stream_360p/playlist.m3u8
Or something different?
Would it need an mp4: beforehand or not?
Seen docs stating both with and without, the working stream was migrated from streaming server v3 so not sure if that affected the config.
Next, are there any special steps to get transcoding setup when restreaming an existing stream or is there any reason why its not working?
Transcoding is enabled for this application.
Application is set to use transcoding template based on stream name (doesn’t exist) or a generic template (does exist)
Generic template for application appears error free and has several profiles (including 360p as tests above) enabled.
No extra streams appear in the incoming streams section as they do for other live application.