Results 1 to 2 of 2

Thread: ModuleAVMix

  1. #1

    Default ModuleAVMix

    Hi,

    I have a video and audio available in two different locations and I would like to mux together the sources to produce a single AV stream. Since the encoders arent shared the timecodes will be very different.

    I intended to use FFmpeg to inject timecodes into the stream at the source (before it gets to wowza) so that i can then tie together the sources as closely as possible. I can also make adjustments in the ffmpeg codes to allow for any delays that I need to introduce.

    My question is, what "timecode" does Wowza listen to? There are lots of different ways of doing that..

    Thanks,

    Joe

  2. #2

    Default

    Hello Joe,

    First I woudl point you to this section in relation to how timecodes are used within Wowza:
    https://www.wowza.com/forums/content...zation#console

    I would also like to point you to the following article on FFmpeg:
    https://www.wowza.com/forums/content...rver-(MPEG-TS)

    Please let me know if you have any remaining questions after reviewing these articles.

    Regards,
    Jason Hatchett

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •